13 best jbl car amplifiers

Product description

1800W peak (760W RMS) Club Series 5-channel amplifier

• 45 watts RMS x 4 + 320 watts x 1 @ 4 ohms
• 65 watts RMS x 4 @ 2 ohms + 500 watts x 1
• 130 watts RMS bridged x 2 @ 4 ohm
• Total peak power: 1800 watts
• Slim chassis provides more flexible mounting options

User questions & answers

Product description

1000W peak (400W RMS) club Series 4-channel amplifier.

• 70 watts RMS x 4 @ 4 ohms
• 100 watts RMS x 4 @ 2 ohms
• 200 watts RMS bridged x 2 @ 4 ohm
• Total peak power: 1000 watts
• Slim chassis provides more flexible mounting options

User questions & answers

Product description

A 435-watt, four-channel, full-range powerhouse, the GX-A604 -with on-board variable electronic crossovers and variable Bass EQ on the rear channels -is certainly a versatile system building tool. With all that power inside a 2-1/16" (52mm) high, 8-1/8" (206mm) wide and 11-13/16" (300mm) deep package, the GX-A604 is easy to install yet can serve as the foundation of a truly sophisticated sound system

• 60W RMS X 4 into 4-Ohm
• 85W RMS X 4 into 2-Ohm
• Cast-aluminum heat sink
• Built-in electronic crossover networks
• Switchable bass boost

User questions & answers

Product description

For more than four decades, JBL has made the audio experience A lot more satisfying for the car audio enthusiast. With a broad array of loudspeakers, amplifiers and subwoofers available, You can drive with ease and exhilaration. Features: value engineered Compact footprint full on-board protection reliability Input level control switchable bass EQ crossover mode switch crossover control gives user additional fine tuning

• General specifications Power output90wx4@4ohms frequency response20-20khz±1db thd@rop1%
• Input Sensitivity0.2V-5v high Pass filter, variable32-320hz low Pass filter, variable32-320hz bass eq@45hz0-12db protectiondc, OVP, UVP, OCP, OTP

User questions & answers

Product description

JBL 400W 4 Channel Class H High-Performance Car Amplifier CLUB A754 This listing Includes: Club A754 4 Channel Amplifier Bare wire-to-RCA Adapters 30A ATO Fuses (2 Installed, 2 Spare) JBL Stickers Mounting Screws (M4 x 53mm) Owner's Manual The Club A754 4-channel amplifier delivers a powerful 75-Watts RMS to each of the front and rear speakers in your car. You can also bridge the amp to 2-channel mode to drive a couple subs with 200 watts RMS or 3-channel mode to drive both a pair of full range speakers and a subwoofer. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your car's factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics. Features: 75W RMS x 4 @ 4 Ohms (100W RMS x 4 @ 2 Ohms) 200W RMS x 2 @ 4 Ohms in Bridged Mode (4 Ohm Stable Bridged) Variable high- and low-pass filters (32-320Hz, 12 dB/octave) on front and rear channels Preamp and speaker-level inputs Preamp Outputs Fuse Rating: 30A x 2 8 Gauge Power and Ground Leads Recommended - Wiring and hardware not included with amplifier Dimensions: W x H x D 320mm x 51.3mm x 180mm 12-5/8" x 2-1/16" x 7-1/8"

• The Club A754 4-channel amplifier delivers a powerful 75-Watts RMS to each of the front and rear speakers in your car. You can also bridge the amp to 2-channel mode to drive a couple subs with 200 watts RM
• 30A ATO Fuses (2 Installed, 2 Spare) JBL Stickers Mounting Screws (M4 x 53mm) Owner's Manual
• Preamp and speaker-level inputs Preamp Outputs Fuse Rating: 30A x 2 8 Gauge Power and Ground Leads Recommended - Wiring and hardware not included with amplifier
• Dimensions: W x H x D 320mm x 51.3mm x 180mm 12-5/8" x 2-1/16" x 7-1/8"
• Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your car's factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics.

User questions & answers

• Max Power1000W Peak
• RMS Power Output @ 2Ω100W x 4, <1% THD+N
• RMS Power Output @ 4Ω70W x 4, <1% THD+N
• RMS Power Output, 4Ω Bridged200W x 2, <1% THD+N
• Signal-to-Noise Ratio>85dB (ref 1W output @ 4Ω)

Product description

The JBL Club A600 mono subwoofer amplifier delivers 600-Watts RMS using a Class D amplifier design to ensure high output and minimum current draw. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your car’s factory radio. You can use the low-pass filter and variable bass boost to maximize the performance of your subwoofer and enclosure, while a phase switch ensures that the bass will blend well with your full-range speakers.

• Premium JBL Sound with 600W X 1
• Compact size
• High and low level input
• Variable crossover and bass boost
• Wired Remote Bass Control

Product description

JBL DSP Amplifier is an audio processor for fine-tuning of aftermarket audio systems. It is a self-contained audio system with 6-channel audio inputs, 8-channel powered audio outputs, an easy to use tuning interface a novice can understand and detailed tuning capabilities to satisfy even experienced installers. With a USB connection to access the tuning interface using a Windows PC, you can control fully variable crossovers, selectable 0-to-48dB slopes, time delay, 31-band parametric or graphic EQ adjustment, assignable input to output mixer with input channel summing, channel gain, master volume control, clipping indicator to ensure the audio output is not distorted and ability to save up to 10 presets. What’s in the box: DSP Amplifier Wiring Harness USB Drive with Tuning Software USB Tuning Cable Wired remote level bass control Mounting hardware 6 x hi level input adapters Spare fuse 4 x wire ties 2 x JBL sticker Quick Start Guide Technical specifications: Max Power: 1000W peak RMS Power Output @ 2Ω: 60W x 8, Less Than 1% THD+N RMS Power Output @ 4Ω: 40W x 8, Less Than 1% THD+N Variable crossovers with hi-pass, lo-pass, band-pass capability & adjustable 0–to–48dB slopes Selectable EQ adjustment: Parametric or Graphic Selectable 12V/Signal Sense/DC Offset turn-on modes, with 12V remote output Frequency Response: 10Hz to 22kHz @ -3dB Signal-to-Noise Ratio: >90dB @ 4Ω Subwoofer Level Control: -30dB to +6dB Fuse Rating: 40A Operating Voltage: 8V to 16V

• Small footprint, All-in-One Class D Amplifier with DSP Control: JBL DSP Amplifier has everything you need to create a professional sound quality audio system with the ability to mount your amplifier in tight spaces.
• Everything You Need to Get Started: JBL DSP Amplifier has everything you need to create an audio system, or expand your existing one, plus the ability to add more power by using it as a line driver when you are ready for your next power upgrade.
• Simple Tuning Interface with Complex Features: Easy-to-use tuning interface anyone can understand, learn and control with enough horsepower to satisfy experienced installers.
• Versatile Connectivity: This amplifier has balanced differential inputs to provide you with the best sound quality & noise rejection, can accept RCA or speaker-level inputs so it’ll work in almost any system.
• Convenient Bass Control: Wired remote control allows for quick adjustment of low frequency output with -30 to +6dB adjustment directly from the driver’s seat

Product description

1300W Peak (650W RMS) Club Series Class D Monoblock Amplifier

• 370 Watts RMS x 1 @ 4 ohms
• 550 Watts RMS x 1 @ 2 ohms
• Total Peak Power: 1300 Watts
• Slim Chassis design to fit more vehicles
• Variable Bass Boost

User questions & answers

Product description

Bass delivered with style Amp technology has come a long way since a 1000-watt amp would take up most of your trunk. JBL's Stadium 1000 mono amplifier powers your subwoofer with up to 1,000 watts RMS from a compact chassis that takes up very little space. A low-pass filter clears the way for your sub to play clean, powerful bass, while a bass boost and phase switch help you get the sound just the way you want it. And JBL includes a wired remote control so you can adjust the bass level from the front seat. Connectivity This amplifier can accept low- or speaker-level inputs so it'll work in almost any system, and the package includes screw-on RCA-to-bare wire adapters for the speaker-level signal. JBL has also included their electrical anti-rotational locking (E.A.R.L.) ground terminal, for a more conductive and secure ground connection for the amplifier. The Stadium 1000 sub amp will integrate perfectly and look fantastic in a system that uses the matching JBL Stadium 4 four-channel full-range amplifier. Stadium 1000 input and control panel

• 700 watts RMS x 1 at 4 ohms
• variable bass boost and phase switch
• preamp and speaker-level inputs

Product description

4-channel car amplifier 100 watts RMS x 4 at 4 ohms 240 watts RMS x 2 in bridged mode Separate variable high- and low-pass filters Preamp inputs and outputs Fuse rating: 30A x 2

• 4-channel Car Amplifier
• Separate Variable High- And Low-pass Filters
• Preamp Inputs And Outputs
• Fuse Rating: 30A X 2

Product description

Brand new in box!

• Carbon-injected plus one cones are larger than others in their size class, meaning they move more air and make more bass
• Soft-dome tweeters feature oversized voice coils for greater heat dissipation and higher power handling resulting in smooth, fatigue free highs
• The patented i-mount system allows unparalleled flexibility whether you flush- or Surface-mount your component tweeters
• A dual-level tweeter volume adjustment helps compensate for less-than-perfect speaker placement, and can even be set to suit your personal listening preference and musical taste
• Low-impedance, three-ohm speakers compensate for the undersized wires found in many of today’s cars, and make the most of every watt your car stereo can deliver

User questions & answers

Product features

JBL Premium 6.5-Inch Component Speaker System - Set of 2

JBL engineers designed the GTO 609C component speaker to produce strong, clear sound from a head-unit or amplifier capable of delivering up to 270 watts of power. This makes the GTO 609C an ideal match to systems powered with head-unit or factory-amplifier power levels. Even better, the speaker matches many of the GTO Series amplifier combinations. As a result, it can keep up with systems that feature one or more subwoofers and satisfy high-fidelity audiophile listeners. And its great power-handling specifications also increase reliability over the lifetime of the speaker.

The GTO 609C’s Plus One carbon-injected cones provide more overall speaker-cone area than other cones in its class. With an effective increase in cone area, the speaker radiates more air. Also, its carbon-injected cone material produces a lighter and stiffer cone. The result is a better low-frequency response and a greater ability to make those important musical notes that people often associate with larger speaker sizes.

Product description

The JBL GT-BassPro12 powered subwoofer pumps out lush, car-rocking bass through a design so cool you won’t want to hide it in your trunk. The patented Slipstream port design delivers deep bottom end while minimizing turbulence. Turbulence, or port noise at high volume, isn’t just annoying; it’s a signal that the port is no longer working and you’re getting less bass than you paid for. The Slipstream design is carefully optimised for the combination of woofer, amp and enclosure, and no other company has it. And with the included remote control for drive-time adjustments, the only time you’ll need to stop is for gas.

From the Manufacturer

• 12-Inch (305mm) woofer with die-cast aluminium basket for solid sounds under all conditions
• Slipstream port eliminates port noise and provides distortion-free bass at high output levels
• System optimisation: amplifier is precisely matched with woofer, enclosure and Slipstream port to ensure best performance and value
• Signal-sensing turn-on automatically turns the subwoofer on and off when the head unit sends an audio signal; can be defeated for use with aftermarket radios that include a remote turn-on lead
• Input level, low-pass, bass-boost and phase controls make it easy for any user to get the desired sound

User questions & answers